The complete guide to connecting a pool vacuum

Table of Contents

This guide is going to show you how to connect your pool vacuum. There are two ways to do this- using the suction side or the pressure side.

Using the Suction Side

1. Attach the pool vacuum to the skimmer.

2. Turn on the pump and let it run for a few minutes to get the vacuum head wet.

3. Vacuum the pool.

4. Rinse the vacuum head and store it away.

Using the Pressure Side

1. Attach the pool vacuum to the inlet valve.

2. Turn on the pump and let it run for a few minutes to get the vacuum head wet.

3. Vacuum the pool.

4. Rinse the vacuum head and store it away.

Both the suction side and the pressure side of the pool vacuum can be used to clean the pool. The suction side is attached to the skimmer, and the pressure side is attached to the inlet valve.

The pool vacuum can also be connected to the garden hose. The garden hose should be attached to the pressure side of the pool vacuum. The suction side should be attached to the skimmer.

how to connect automatic pool vacuum?

There are a few ways to connect an automatic pool vacuum. One way is to connect it to the pool’s skimmer. Another way is to connect it to the pool’s pump. The third way is to connect it to the pool’s filter.

The skimmer is the most common way to connect an automatic pool vacuum. The vacuum is attached to the skimmer’s inlet valve. The pump should be turned on and allowed to run for a few minutes to get the vacuum head wet. The vacuum can then be used to clean the pool.